We say that repairing the Whirlpool electric dryer, in the absence of heating is not hard to do a job if you know what to look for to get started.
The heating of the oven Whirlpool includes the following parts. The timer, heater, hi-guard, the safety thermostat, operating system, thermostat, thermostat and the motor centrifugal switch.
If any of these parts fail, the dryer is not heating. Well, most people, when the dryerwarming stops, replace the heater or the timer to check to ensure that the parts are bad. Rule number one is, do not assume that the bad part with out checking with a tester.
The first and most important, you have to do is to unplug the dryer from the electrical outlet before performing any work on it. Most of the parts should be checked for continuity and the dryer must be disconnected from the electrical outlet.
Most of the time caused the partialThe problem is that behind the camera and can be accessed by going to earn it again.
Remove the back of the oven. Drag a wire heating element and a measure of the resistance between two terminals. The value should be 10-50 ohms. If the heater is good, control of the hi-limiter to be one of the wires and check continuity. Means continuity could pass the current through the component youReview.
Hi-line blowing if there is an obstacle on the exhaust pipe, so be sure that the vent pipe is not blocked, while the hi-limit switch kits.
When the hi-limiter and the heating element are in place, check the thermostat operating system. The thermostat function is to maintain the temperature within the drum at about 150 degrees. Must come from two terminals with the red wire attached to her to check.
Those in which the partiesfail more frequently in the whirlpool electric dryer. The timer, the motor centrifugal switch, thermostats are a bit 'more difficult to verify because there are a variety. You must use your wiring diagram to see how to control.
